bayourunner

I have hit and scrapped the crossmember a few times nows... is they any options like a thinner aftermarket crossmember or something?

I did notice the ends seem just as low and that's what they bolt into so not sure how much that would help.

I have a djm 3 / 5

Thx

dmonik

Cut it off an reweld inside of frame rails. The middle of it will have to be modified to fit the tranny

bayourunner

Thx bud that's what's I was thinking also. Even if you would put a smaller cross member you would still have the two low mounting points. I'm about to order my 22s with the biggest tire I can run which will give me slightly more ground clearance.

dmonik

dmonik

General idea. Believe he was 5" upfront. I'm at 4" right now wanting to go to 5". Mines not a daily driver so the crossmember scraping isnt that big of a deal to me. I do want to notch the rear so I can go out my 2" shackles in for 8" total

bayourunner

I got ya... Thanks. Yea mins a DD.

I'm getting 22s x9 32 offset with 285/45/r22 xl nitto 420s so that will give me almost 1inch ground clearance. So I may be okay I just hope they don't rub. At at 3/5 atm