What did you do to your 10th gen today?
Now an XLT in Colorado
So today.......
Well today I started mocking up my supercharger pulleys. But before that, I moved my radiator further from the engine( over 2 inches),installed my lincoln mark 8 dual,2 speed cooling fans. Right now the fans on low speed keep my truck right at 170° with AC off. Gonna wire in the ac /high speed on relay . Also a thermal switch for low speed control. The high speed is hooked to a 185° on 165° off.
GO SOX!
Senior Member
iTrader: (1)
Now an XLT in Colorado
I installed the 22" Magnaflow I had on the '99. I'd forgotten how little difference in sound there is. A bit lower tone, but just as quiet. I'll have to consider an 18" in the future for a little more growl, but for now, the increased flow was probably worth the $16 in clamps, and the scrap 2-1/2" pipe I had.
.
.
Last edited by OhioLariat; 06-25-2017 at 05:43 PM.
Senior Member
Resealed my rear window (3rd time in as many weeks, long story :/), installed new drilled and slotted rotor and new pads all around and rotated my tires. Next on the list is finishing replacing front end parts, torsion bar crank and an alignment
oh and Friday I had true dual Flowmaster 40s with an x-pipe and 3" tips installed
oh and Friday I had true dual Flowmaster 40s with an x-pipe and 3" tips installed
Senior Member
Changed over the Fog & Reverse lights from the ones fitted when it was convered for use in the UK to these
I think they look a lot better...
Just got to get the cutting wheel out next to remove the little brackets above them that the old ones were bolted onto so I can start using the tow hitch if needed... Currently they are just in the way for putting the pin through... Doh
I think they look a lot better...
Just got to get the cutting wheel out next to remove the little brackets above them that the old ones were bolted onto so I can start using the tow hitch if needed... Currently they are just in the way for putting the pin through... Doh
Now an XLT in Colorado
Changed over the Fog & Reverse lights from the ones fitted when it was convered for use in the UK to these
I think they look a lot better...
Just got to get the cutting wheel out next to remove the little brackets above them that the old ones were bolted onto so I can start using the tow hitch if needed... Currently they are just in the way for putting the pin through... Doh
I think they look a lot better...
Just got to get the cutting wheel out next to remove the little brackets above them that the old ones were bolted onto so I can start using the tow hitch if needed... Currently they are just in the way for putting the pin through... Doh