What did you do to your 10th gen today?
Senior Member
iTrader: (1)
Senior Member
Well, at least you know it isn't unusual...I went through the same crap with mine. I thought I bent the brackets somehow, but there was really no way. I heard if you remove the cylinders first by the hinge latch assembly, then over extend that assembly backward (open the hood too much), you can bend just the assembly (hinged bracketry) out of shape. Well, just something to drive you nuts ehhh lol.
Also the right (passenger side) side front fender /hood spacing looks off. THAT I remember well! Mine did the exact same and right where yours is. Do you still have the adjustable bump stops in place ? They have been known to fall out or harden. Adjusting those can change how it looks when closed. Might be able to manipulate the vertical reveal that way from the side, but then you have to watch hood gap. Before you know it, your re-adjusting the entire front clip lol. Yup PITA !
Last edited by Jbrew; 05-04-2018 at 12:30 PM.
GO SOX!
The following users liked this post:
Tav29 (05-07-2018)
Member
The following users liked this post:
Tav29 (05-07-2018)
Painted 2x4's creates small compartments for supplies and also can lay plywood and sheet rock flat instead on an angle over the wheel well.