What did you do to your 10th gen today?
Senior Member
WOW
The following users liked this post:
David F-150 (10-02-2016)
Just picked up a set of 3 American racing wheels. Going to order another one this week then get some 33s for the truck. Then I'm going to start fixing her up. Still need a boost control solenoid for my other car and 37s for the other truck but oh well.
Senior Member
iTrader: (1)
Lol well you do have a lot going on.
I had alittle fun with plasti-dip saturday and sunday. I tried searching and searching and havent found any like it, I wanted to do the raptor "splash" but this version is so much easier. I originally was going to remove the "4x4". But my brother being the master taper that he is, did all the taping and outling for me, I just did the measurements and painting. Just have to figure out to do something on the tailgate area.
Senior Member
I had alittle fun with plasti-dip saturday and sunday. I tried searching and searching and havent found any like it, I wanted to do the raptor "splash" but this version is so much easier. I originally was going to remove the "4x4". But my brother being the master taper that he is, did all the taping and outling for me, I just did the measurements and painting. Just have to figure out to do something on the tailgate area.
Senior Member
iTrader: (1)
2 cans will be more than enough. Use the glossifier afterwards and it will last much longer without fading.
The following users liked this post:
petef-150 (10-03-2016)
I bought 2 can, ended up only using 1/2 can per side. That's with doing 4-5 heavy coats. But I would say 2 should be good enough. Just make sure the panel is nice and clean, and in the shade. When I did my driver side we were in the sun, And there is a-little bit of tiger stripes in it. Nothing major, Just going to re-do it later this week.
The following users liked this post:
petef-150 (10-03-2016)