very bad transmission problem
#51
Had the scanner read what was on and off while selecting different gears and with and without o/d. I didn't change the plug that goes through the trans case. Possible that using the 98 wiring harness burned out the pins in that plug?
#52
Senior Member
Are you sure when you replace the pump seal the piston bleed hole is positioned @ 12:00?
Last edited by w0lvez; 06-02-2014 at 07:31 PM.
#53
I changed the tc seal. Same one your talking about? No I didn't see anything on it that would need to be positioned a certain direction
#54
Senior Member
CHECK THIS LINK......
Last edited by w0lvez; 06-03-2014 at 09:39 AM.
#56
The Bleed Hole should be at 12:00 position like the one in the picture below..
CHECK THIS LINK......
CHECK THIS LINK......
#59
Senior Member
#60
I did not have enough room to pull the tc all the way out. I did switch the valve body and harness. It is a 98 4r70w so I left the shift and tcc solenoid in. What is the tr sensor? Alright swapped the range sensor