LOUDnLIFTEDf150

yea I think so that's what I had planned on doing I guess I'll just have ta climb under the truck and measure my stock blocks to see

Jackedup00

Stock should be 2".

LOUDnLIFTEDf150

ok thanks man

LOUDnLIFTEDf150

how exactly do u measure blocks cuz just measured on my truck and from top of axle to top of block it's about .5" but it curves and goes about halfway down each side of my axle and if I measure from their to the top it is 2"

Jackedup00

Take a picture of it

LOUDnLIFTEDf150

ok I will

LOUDnLIFTEDf150

here it is



















I also saw that this line was broke in half what is this line ?

Jackedup00

Those look like bump stops,if you get a 3.5" spindle and keep your level you'll need to take those out and put a 4" block in.

F150_NAMED_CLIFFORD

That line is a breather tube for your diff , what you could do is clean that hole, then take off the part that's stuck to the diff, then just re connect the tube that's there

LOUDnLIFTEDf150

ok will it still sit level?