Size of our radiator.?
#2
Senior Member
#3
Senior Member
Thread Starter
I can wait until tomorrow, when I get home to Fort Worth from Houston... I'll walk next door to my neighbors house to borrow his tape measure.
Just figured I could have a day's head start on ordering metal.
#4
Senior Member
Yea, measure your own damn radiator
#7
Senior Member
Thread Starter
Jbrew was kidding ish
Since you forgot what you had said, I'll let you re-read it.
Since you forgot what you had said, I'll let you re-read it.
Trending Topics
#8
I'm not sure where you'd want you shroud to cover. If you want to stop at the fins horizontally or if you'd want to go to the aluminum lip that connects to the plastic tanks.?
32.5" wide -1/4" for the lip
18" Tall
3' on the diagonal.
32.5" wide -1/4" for the lip
18" Tall
3' on the diagonal.
The following users liked this post:
harley9703 (09-27-2015)
#9
Senior Member
#10
Senior Member
Thread Starter
No this is perfect, this is about what I remembered... I've been looking at 36x36 sheets, but this could possible knock down some cost.
I'm actually thinking aluminum diamond plate.
Not sure if I'll have enough surface to take it off my tool box or not. (back or front side) it's a deep box, but not sure if it's deep enough. But none the less diamond plate is the cheapest over aluminum sheet metal.