Hi

 

You have a certain bulb your using for these raptor lights

 

I used a small L bracket and I mounted 3 LED amber strips on each and mounted behind the grille with 3M tape. They're nearly invisible when they're off....
Before, all one strip


after I cut it into 3 LED sections and put onto the L-brackets

 

When u cut that led strip how'd you get wires attached to the other 2 that u cut away from the main piece. Sorry for all the questions I'm new to modding lights. But so far it's been fun

 

How hard was it to get the halo system done I really want to do it to mine but I have heard its hard

 

It's cool man, I just stripped off a little of the waterproof coating from the lights to get to the copper pads you can see in the pic. Then I soldered wire leads on and put heat-shrink tubing over the connection so it's waterproof. You can drive through the rain with them, but I wouldn't stand there and pelt them with a pressure washer at the car wash or you might damage the strips.

 

Right on , think I'll go to the zone tomorrow and pick up some amber LEDs

 

getting some hella 500ff and 700ff for christmas. are the 100w bulbs worth it? really want the extra light output

 

They fill out the housing more, don't know how much brighter they are though, I put 100w in mine when I first installed them. They did make my old off brand lights brighter when I had my bull bar.

 

Got some super bright LEDs in my cab now and i got a whole new third brake light assembly that is full LED and tinted with the original slots for the cargo bulbs.