Leveling Kit 2002 F150
#3
Senior Member
Ya dude, when you buy the aftermarket keys it allows you to crank them too much and you'll end up wearing out the front end. Just crank up the factory ones. All you need is an 18mm socket and a 3/4in ratchet if you have one. More people on here have done that than have bought the lift keys.
#6
Senior Member
To keep it even on both sides I did it a quarter turn at a time. And if I recall it was 8 or 10 quarter turns. So between 2 and 2 and a half full rotations of your wrench. Start at about 1 and a half turns, then drive it around a little before you see how much it raised up. If you want more then crank more. It's pretty simple.
#7
Senior Member
I believe It was 24 3/4 inches from the center of the axle to the bottom of the wheel opening was the max you should go otherwise you wear parts out faster
Trending Topics
#8
Thank You! Is there a diagram to where they are located? And 4x4Dustin what are lift blocks? It says that in the modifications on your page? Thanks Again I will do that!
#9
F150 Manic
The following users liked this post:
F1504x4Ford (12-18-2012)
#10
Senior Member
Honestly I don't even know why I put those on there all I have is just the stock lift blocks.....but basically they lift the leaf spring pack up off the axle and in turn gives you lift.
The following users liked this post:
F1504x4Ford (12-18-2012)