Fog light wires for 98 Ford f150 xlt 4x4
#41
Senior Member
We more than get our share of snow, Anchorage AK area, so I can sympathize with you. lol. If you looked at my front pictures, only the damn bumper bar braces have rust on them. Nothing else on this truck has any rust. It's weird how the bars, front and rear are the only place to show any rust. Must be the swirl effect of the wind and road crap that chips the paint and causes the rust. I don't know what else it could be, except cheap metal. Nah. Not on an American vehicle. lol
#42
Your pics 10-12 show the opening where the wiring is suppose to come out on the right side. I do not see the "Y" off connector. Look at my pictures of the right side of my harness and you will see where the "Y" hooks into the harness. I do not see it on yours. Check that second wire loom and see if it is tucked inside the horn a bit. If not, then, I'm sorry to tell you, but it isn't there, and you will have to make up a quick harness to make things work. Hope this helps
#43
Senior Member
Try this and see if this fits your use. It should work perfectly for you. It may say Toyota but it is basically universal. Power, ground, etc.
http://www.fordf150.net/howto/foglights.php
http://www.fordf150.net/howto/foglights.php
Last edited by akdoggie; 04-13-2014 at 09:04 PM.
#44
Senior Member
You can also use this. It is more simplified and says HID, but it is the same for regular bulbs. Good luck.
#46
Senior Member
That is what this thread is all about. You have to look under your front bumper where we have shown and see if the harness is there. If you have a bumper without the holes for the fogs, it is doubtful. Otherwise it is a tossup.
#47
Alright thanks! Sorry for the dumb question lol
#48
cliffords a 4x4
did you guys find 'em? you got my attention now, oh and by the way i have the same problem i have the bumper with fogs but cant find the harness and have the switch that was posted earlier (with out fog light drawing)
#49
Senior Member
Just look at the extreme right of your front bumper, look underneath, find the horns, then look at the hole in the front core support. It will have at least 2 wire harness come out. The one with the "Y" making it three wires is the harness you need. If you don't have the "Y", then you will need to install a fog light harness of your own or aftermarket.
Just curiosity, does your serial number start with a 2 or a 1? I'm thinking the Canadian models (2) have the harnesses, and US (1), maybe not? Just a thought.