Engine Builders talk.
#7002
Resident light whore
Mine was only around $350 for a valve job and decking.
#7003
Senior Member
#7004
Resident light whore
#7005
Just called my shop,$250-$300 for the heads. Not bad,that'll put me at $1700 total labor for the motor.
#7006
Senior Member
iTrader: (2)
I am with you, enough of these BS posts and one/two word responses like "ok lol", and [MENTION=113]Jbrew[/MENTION] I thought more of you than to get cocky on a fellow forum member who is correct in saying this thread is for engine related topics. Pages and pages of BS is getting ridiculous.. Derek, come on, calculus in a build thread?
He does have a point, all the relevant and informative post are getting cluttered up behind bs.
The following users liked this post:
fordmotorsport (01-26-2015)
#7007
Senior Member
#7009
Senior Member
I am with you, enough of these BS posts and one/two word responses like "ok lol", and @Jbrew I thought more of you than to get cocky on a fellow forum member who is correct in saying this thread is for engine related topics. Pages and pages of BS is getting ridiculous..
Derek, come on, calculus in a build thread?
Derek, come on, calculus in a build thread?
I did all that for ibd because he asked me to. I asked for specifics on the drive-shaft measurements, -no answer. So I crawled under the truck and took more than just one just in case. It was a PITA doing that with a tape.
Then , never answering PM's. Since he obviously doesn't need the info anymore, you don't just dis the guys helping you get it. Who does that?? Nevermind, I know the answer. Sorry this happened here, but like I said, man on man doesn't work with this guy, he runs away. Runs from taking responsibility for his own actions. That's the REAL BS.
It'll end here, doing that to me or anyone els for that matter just isn't cool.
#7010