Odometer Display Going Out (?)
#1
Senior Member
Thread Starter
Odometer Display Going Out (?)
My 2000 ODO display has been intermittent. The brightness level varies and sometimes is blank for a while after I re-start the Truck.
Anyone know the cause or a fix?
Anyone know the cause or a fix?
#2
Senior Member
It's a common issue the solders are bad on the circuit board on the odometer same with the overhead console/compass/Temp readout. look it up on youtube or in the how to section there is a few threads about this. All you have to do is redo the solders and that's the fix.
The following users liked this post:
Tundra Dweller (09-14-2015)
#3
Senior Member
Thread Starter
It's a common issue the solders are bad on the circuit board on the odometer same with the overhead console/compass/Temp readout. look it up on youtube or in the how to section there is a few threads about this. All you have to do is redo the solders and that's the fix.
Thank you!
#6
Odometer Display Going Out (?)
Originally Posted by Holicori
How time consuming is this? I assume you need to get behind the dash?
#7
Do some searching on this site, and you tube, etc. The dash does not have to come out, but the cluster does. Then you take it apart, clean it while you're at it, and solder up the right locations. I found 3 cracked solder locations. And if you find the right sight, it will show the exact solder location to fix the problem. Total time invested is about 3 hours if you've never done it before.
Check this link: http://www.ford-trucks.com/forums/19...lem-fixed.html
Careful with the "PRNDL" removal and install - it slides up and down.
Check this link: http://www.ford-trucks.com/forums/19...lem-fixed.html
Careful with the "PRNDL" removal and install - it slides up and down.
Last edited by fordysenior; 09-16-2015 at 09:04 PM.