Chopping the stock muffler...
#21
Member
Thread Starter
OK so it sounds good but...
Its buzzing right of idle and when I turn the wheel etc. I dont see anything touching. Is there a heat shield somewhere that might be the culprit?
Its buzzing right of idle and when I turn the wheel etc. I dont see anything touching. Is there a heat shield somewhere that might be the culprit?
#22
Senior Member
You might have one pipe rattling inside another. Make sure the clamps are tight. If you used U-bolt clamps (we did) you have to snug them down good. Do it again after a couple heat cycles.
#23
Senior Member
These are pretty decent clamps by Walker. These are what I am using on mine.
This is the Flowaster HP2 that's going in there. Just need to do some modification for the offset.
#24
Member
Thread Starter
Serves me right I guess because now its rattling. Suppose I could let the monkeys at the shop adjust it.
Last edited by Skunkbuttrug; 08-17-2016 at 11:14 PM.
#25
Beer, Boats, and Trucks.
yeah there are a lot of cheapo clamps out there. I'm using the Salvo Auto POS Ubolt clamps and they are horrible. The stainless steel turned brown after 3 days on the truck. I'll be replacing them with some band clamps soonish.
Glad you like the sound though! You dont have a resonator in your gen truck which makes it sound a little bit different from say the 12 gen trucks. Glad you like it though!
Glad you like the sound though! You dont have a resonator in your gen truck which makes it sound a little bit different from say the 12 gen trucks. Glad you like it though!
#26
Member
Thread Starter
Got the rattle fixed. The heat shield around the lower cat was loose. I ran up to parts store and replaced it. Much better.
Truck is sounding sweet. Thanks again everyone for their help. I recommend straight pipe muffler delete to anyone on the fence about it. Its excellent.
Truck is sounding sweet. Thanks again everyone for their help. I recommend straight pipe muffler delete to anyone on the fence about it. Its excellent.
The following users liked this post:
PerryB (08-18-2016)