Cheap, Easy, Fun Mods!!
The following users liked this post:
Auburnfan400 (02-18-2013)
#12
Senior Member
I've done the LED swap in my cab light and map lights, the zip-tie mod to the throttle cable, put nightshade on the corner lights and painted the emblems and grill a few years ago. Still looks good today, only 1 or 2 small chips from rocks.
Before
During
After
Before
During
After
Last edited by Auburnfan400; 02-18-2013 at 11:06 PM.
The following 3 users liked this post by Auburnfan400:
The following users liked this post:
JGORMAN (11-01-2021)
#14
Super Moderator
Easy? Its not difficult, just time consuming. Driver side only though. Unless you want to remove the E-brake... I ended up putting my door lights back in that ford jipped me of. Should only be about $20-$25. Depends on how much the wire is that you get and how much the clamps are. I did a write up of it a bit ago, i'll give a link for any who are interested. If you want full potential, go get the clear lenses afterwards. Get them from the stealership or LMC truck. I got mine for $5.44 a piece. This is optinal, but i strongly recommend it. Here are mine at night with clear lenses:
Last edited by 03f15012; 02-18-2013 at 05:02 PM.
The following users liked this post:
GishGotSpots (10-22-2022)
#15
Where'd you get that emblem
The following users liked this post:
Pickeringco95 (06-15-2016)
#18
2015 F-150 3.5 ecoboost
Bedliner your rockers. Plasti-dip bumpers and grill and center if good and wheels.
During the Bedliner. Did it myself
Plasti dipped wheels
All done.
Srry don't have a pic of rear bumper right now it's been Plasti dipped too.
Plus got a locking chrome gas door that I Plasti dipped. The scoop is functional I made it work lol.
For that just basically cut a 3in hole in hood and used duct work and such to make it work. Found some flat plastic duct work. And put a y pipe connector when did gotts mod so all the air goes through filter. Even made a flap type so if raining I close it. Works pretty good.
During the Bedliner. Did it myself
Plasti dipped wheels
All done.
Srry don't have a pic of rear bumper right now it's been Plasti dipped too.
Plus got a locking chrome gas door that I Plasti dipped. The scoop is functional I made it work lol.
For that just basically cut a 3in hole in hood and used duct work and such to make it work. Found some flat plastic duct work. And put a y pipe connector when did gotts mod so all the air goes through filter. Even made a flap type so if raining I close it. Works pretty good.
The following 2 users liked this post by OTG02:
GishGotSpots (10-22-2022),
ultimatenoobie (01-15-2022)
The following users liked this post:
dj1975 (12-21-2015)