Originally Posted by 2000MTZ

Ok, Next up the Headlight Switch

To do this you do technically have to 'break' the switch.

First Pull the **** out like for fogs and stick something small in the hole to release the ****, now just pull it off

To get to the inside you have to pop the faceplate off, this is what I mean by breaking it.
Attachment 503012

Undo these 2 clips to the first half can pull out
Attachment 503013

grab the shaft and pull it out
Attachment 503014

The next half is harder to get out, the clips are harder to get to, you can see them here
Attachment 503015

Now pull that half out
Attachment 503016

Here is the bulb that your replacing, and the green cover that was on it that I ripped off
Attachment 503017

Now unsolder the leads on the back to pull it off.

Stick the negative lead back in the original hole (lower) and solder it on there
Stick one side of the 680ohm 1/2watt resister in the original hole and solder it on there
Now wrap the positive lead on the LED around the lead on the resistor and solder them together
Attachment 503018

Try to get the new LED as close to the stock bulb location as possible and put the dimmer switch side back in
Attachment 503019

Attachment 503020

Now finish reinstalling the switch parts, I used 2 part loctite epoxy to put the faceplate back on

Alright now your done with the headlight switch

Originally Posted by 2000MTZ

Attachment 503027

Now put some scotch tape on the bottom parts and paint it white, If you dont youll have bad hotspots
Attachment 503028

Originally Posted by CrisAnderson27

I actually cut the green sheet up, leaving just the white part. I still have hot spots but not bad. May go over it with some white paint around the letters..on the white sheet.

Saved me the trouble of messing with tape though!

By the way...GREAT write up...thank you. I did the blue in my 03 on my own not realizing there was green tint. Looked pretty bad lol. Now I know how to fix it!