HarrisRacing17

So I come across another amazing deal my friends. A non supercharged 2004 mustang cobra 4.6 H.O motor with full transmission and computer. And I plan to drop if into my F-150. Does any one know if I will run into many problems? Other thAn wiring. Will it mount into place properly?? I'm fully prepared to lengthen or shorten my driveshaft etc... Comments or any previous projects similar to this?? Pictures would be greatly appreciAted

Sent from my iPhone using F150 Forum

bob101770

Sure it's a 04 Cobra? Thought they were superchared in 03-04. The motor will bolt up to the motor mounts but I'm not sure about the T56 6 speed. You'll probally have make a custom mount or crossmember.

otto457

It should have an Eaton M112 supercharger on it. PCM, wiring, and getting the tranny straight will be the biggest challenges.

FloridaSnowman

No it wont work at all, you wasted you money, I'll take it off your hands and dispose of it properly, where are you located? I'll come get it right now.

+1 on the tranny issue, not sure of the length either, you may have to cut another hole in the floor for all I know.

FloridaSnowman

But I dont recall the 4.6L ever using a double butterfly throttle body....

FloridaSnowman

its an `05 GT engine buddy....

97SC4x4

LOL it sure it, good catch!

HarrisRacing17

Even better lol make me happier tell me its the 5.4? lol i dunno im just going by what i was told it was lol. im thinking of dropping it into a late 80's early 90's foxbody instead make a track car

HarrisRacing17

Next question. i know its highly unlikely. but will my transmission bolt up to this motor if ionly put the motor in my truck?