Texas: Supercharger, road armor, k&N, shocks, level kit

Reply Subscribe

Thread Tools

Search this Thread

05-10-2016, 03:18 PM

Blown5.0

Member

Thread Starter

Join Date: Feb 2016

Location: Columbus, TX

Posts: 46

Likes: 0

Received 2 Likes on 2 Posts

Supercharger, road armor, k&N, shocks, level kit

Moderators, please understand that I have been busy at work so the date on the pic was a few weeks ago. Drilling oilwells.

http://houston.craigslist.org/pts/5576545185.html

I have some items up for sale, please read entire post prior to messaging me.

I have got these items and each one of them has every bit of hardware and installation instructions needed. All items are in good condition, I do not sell junk. I pretty much require it to be an in person trade cash in hand.

•Edelbrock E-Force supercharger kit P/N:1584 kit for the 5.0 f150 2011-2014. $5000
--I bought this kit roughly 3 months ago for $6,600. I put 3,000 miles on it with the Edelbrock tuner that came with it and the truck did not skip a beat. I took the truck to Serious Horsepower (SHP)

in Houston to get a little hotter tune, which is precisely what I got, hot enough to melt shi*. I made it 400 miles of highway driving to south Louisiana and melted the piston in #7. I got a bad tune from SHP and the motor ran too lean. I should have had wideband gauge with that tune on it, or just keep the edelbrock tune which was still wicked fast. This kit also comes with an autometer boost gauge (30vac to 20psi) with the roush vent gauge pod that mounts in any of the HVAC vents. My build thread is in my sig if you want to read up on the install etc. I removed this kit and had to put another motor in the truck and decided to leave my daily stock, so I’ll be eating some serious $. When I removed this kit I kept all hardware in their appropriate holes and taped them in place. This is a 100% complete bolt on and drive kit in perfect condition, you save $1300.

•Road armor grille guard. $375
--I believe I paid $650 for this, It is in great condition and as stated above comes with everything needed to install

•Spare tire from 2013 fx4. $125
--New condition

•K&N Cold Air intake for 5.0L $200
--Comes with MAF for 2011 f150. It can be taken out and yours can be used.

•2013 FX4 front coilovers w/ 2” level spacers and rear shocks. $275
--I put fox shox all the way around at 30,000miles and these have been laying around.

Possible Trade Items include the following, but are not limited to.
-Ford 9" rear end, or 8.8 rear that is shortened to Chevy S10 length. Really any rear end that will fit under an S10 except for the stock 7.5" 10bolt.
-Procharger kit for LS1
-Full wet nitrous kit for 2013 5.0 F150
-Nitrous bottles
-Pistols
-A good running Honda fourwheeler
-A car hauler, or a ~84" wide utility trailer in good condition. Tandem Axles.
-A Freezer that works.
-Zero turn mower in good condition and of decent quality
-Ladder bars for 2-3/4" axle housing
-An ice machine
-Good battery charger
-One of those portable car cover carports
-An LS1, LS2 or LS6 engine assembled.
-F.A.S.T intake for LS 1,2,6
-LS parts in general.
-LS1/Borg Warner T56 clutch assembly.
-Good mig welding machine
-Pretty beefy gas generator
-Small generator
-5 or 6ft shreader/bush hog 3pt pto drive. In good condition.
-115volt electric winch.
-Cutting torch setup.
-Sandblaster
-Electric opening gate
-About a 16ft roll up garage door

-A nice little bass boat or ski boat.
-Jet ski

I am located near Columbus TX. I may be able to meet "half way" within an hour from Columbus and only for expensive items.

Attached Thumbnails