nerdh3rd

iTrader: (1)

Selling a 4" to 8" conversion harness for upgrading to the 8" MFT or Sync 3 system. The harness also has the connector to hook up the 4" display male connector to bring over the rear view camera if yours goes to the 4" display.

There is also power and ground out for a media hub. I can add a WPT-1239 connector for the Sync 3 hub to make it PnP for and extra $35 (the WPT-1239 harness end cost me $30, so it's pretty much at cost).

Wire ends are also in place to tap into the CAN Bus if necessary for your application.

There is a small chip in the corner of the female side connector that can be seen in the pictures. This does not affect functionality or connection at all and is purely cosmetic, but I wanted to note it so a buyer doesn't think it was damaged in shipment.

$240 shipped to the lower 48. Cross posted in 2015+ Parts for sale Section.

nerdh3rd

iTrader: (1)

Bump.

nerdh3rd

iTrader: (1)

Price drop to $220 shipped.

nerdh3rd

iTrader: (1)

$210 shipped. Add $20 for the WPT-1239 pigtail.

nerdh3rd

iTrader: (1)

TTT.

mikejones1477

I need a harness like this for 2012 Ford Explorer xlt base sync with xm..

nerdh3rd

iTrader: (1)

2012 have a different setup and would require most/all of the dash to be swapped. You would be better off going with an aftermarket system.

mikejones1477

I found this this from this one company. Is it not possible.. It is available for 2011-2018 Ford explorer..

https://www.infotainment.com/collect...screen-upgrade

nerdh3rd

iTrader: (1)

Not sure, 2012 F150's it will not work for as far as I am aware, I don't have any experience with Explorers. I wouldn't buy from them without written verification that it's possible and a return policy.

nerdh3rd

iTrader: (1)

Friday morning bump.