FS: HID 5000K H13(9008) headlight and (9140) foglights
#1
Senior Member
Thread Starter
FS: HID 5000K H13(9008) headlight and (9140) foglights
Asking $100 shipped to lower 48
I am selling my HID headlights. They are used and I just took these out of my truck 4 days ago. Reason for selling.....tired of being profiled by police officers in my small local town (Leavenworth County, Kansas) They are in excellent working condition. One of the tabs that slide in to the ballast where it clicks is broke but it came like that when I got it, electrical tape will hold it in place. These are Bi-Xenon meaning they are low and high beam. I did have to change the pin-out when I received it because it was backwards and only the lows would work. I am not sure if warranties transfer over. I bought these from JON_TO (Third Gear Performance) He is an active member on the forum. You will need 3M two-sided tape as you can see in the pictures that it was used. Screws on ballast look rusty but not effecting performance. They worked and I have not had a single problem with them even when it reached -10 degrees outside. They look blue in pictures and green in videos. Color temperature is 5000K, he did not have 4300K which is the closest to OEM ie; BMW, Mercedes.... I paid $160 two or three months ago. These are not the cheap HID's found on eBay, this is a real quality product. They did not come with instructions when I purchased them, there is a good write-up on the forum. Pictures are below, there are also pictures when they were on my truck. My truck was in an accident yesterday, these were not in the truck at the time. I have bubble wrapped everything and put them in individual ziploc bags.
I am selling my HID headlights. They are used and I just took these out of my truck 4 days ago. Reason for selling.....tired of being profiled by police officers in my small local town (Leavenworth County, Kansas) They are in excellent working condition. One of the tabs that slide in to the ballast where it clicks is broke but it came like that when I got it, electrical tape will hold it in place. These are Bi-Xenon meaning they are low and high beam. I did have to change the pin-out when I received it because it was backwards and only the lows would work. I am not sure if warranties transfer over. I bought these from JON_TO (Third Gear Performance) He is an active member on the forum. You will need 3M two-sided tape as you can see in the pictures that it was used. Screws on ballast look rusty but not effecting performance. They worked and I have not had a single problem with them even when it reached -10 degrees outside. They look blue in pictures and green in videos. Color temperature is 5000K, he did not have 4300K which is the closest to OEM ie; BMW, Mercedes.... I paid $160 two or three months ago. These are not the cheap HID's found on eBay, this is a real quality product. They did not come with instructions when I purchased them, there is a good write-up on the forum. Pictures are below, there are also pictures when they were on my truck. My truck was in an accident yesterday, these were not in the truck at the time. I have bubble wrapped everything and put them in individual ziploc bags.
#3
Senior Member
Thread Starter
Here are pictures taken 2-3 months ago when they were first installed on my truck. It took about 2 hours because I wanted it to look clean. It took about 20-30 mins to install the foglights. One pic shows OEM vs HID
#6
Senior Member
Thread Starter