Toronto Maple Leaf Centennial Edition Graphic
 

Any ideas where I might be able to locate the graphic shown below? I actually went to my local Ford dealer and the part's guy checked a V.I.N. # of a 2017 Maple Leaf centennial edition truck they had on the lot. He figured if they sold that edition of the vehicle they would also need to have the decals available as replacement parts but no luck finding the #. There were a limited number of these 2017s available in the Toronto area (I believe 400 trucks were sold). I just had the rear box replaced on my 2016 Platinum (after a minor fender bender) and asked the body shop to leave the 4x4 graphic off the rear quarter panels.
Cheers
Kevin
https://cimg9.ibsrv.net/gimg/www.f15...6fa81c5930.png

Go on Etsy. Only 2 left so can do both sides if you hurry for only Cdn $20.
Leafs Vinyl logo
Not sure why they only made those in XLT. I remember seeing #2 of #400 at McAlpine when they first came out. Took a picture of it but can't find it. Not sure why Summit still has it. Must be waiting to cash in when Leafs win the cup!

So because it's convenient I popped into the HHoF Spirit of Hockey store today to see if they had these. They do but in white (I didn't see any blue). They are the official NHL version and approx 5"H * 4"W and to my surprise are $5 each

Very much appreciate the link and checking out the store. Lot's of neat items on there for sure. I was specifically looking for the same decal style shown in the picture though (i.e the Leaf logo but also the blue stripe that extends down the length of the rear quarter panel). One of my neighbours has the special edition truck and I think the rear decal looks pretty good on there. They did a nice job on that truck but as you mentioned, too bad it was only available in the XLT trim.
Thanks again for getting back!!
Cheers
Kevin

Here is the graphic file. If you know someone with a vinyl cutter, you can have them make it.

https://www.brandsoftheworld.com/log...-maple-leafs-1

I threw this together.
https://cimg0.ibsrv.net/gimg/www.f15...b831ee54f8.png

Well done!! I do know someone with a vinyl cutter so that is an interesting option I hadn't considered. Definitely will check with him to see if this is something he could put together.
Cheers
Kevin

I'll send you the file if you'd like

Here is an EPS file your friend with the cutter should be able to open.

Thankyou!! Very nice gesture there and much appreciated :). If he can put it together for me I will definitely update everyone and send along a pic.
Cheers!!
Kevin