Who will smoke tail lights? couldnt find it?
 

I did a search and couldnt find it anywhere..Who on here has the thread that says he will some your taillights for you? Thanks for the help

this guy just did mine. Really good work.. the best.

http://myworld.ebay.com/smoked_light...:X:CEM:US:1181

want to save some money? go to an autoparts store and buy the vht nights shades spray... i did it to my cost 10 bucks i think.. if its too dark take plastic polish and bufff them they`ll look sick..
i jsut did mine before fall and i like them.
Attachment 14049

Nice!! That does look good, Thanks!

my only advice is do them on the truck. and just mask the truck with newspaper. and do light coats. but for 10 bucks you cant beat it

tails with night shades
 

i took mine out not a big deal clean them with a bug and tar remover make sure thier clean i hung mine from the roof if u lay them flat it will run easier i all so taped off my rev lights it looked so good i did my wife jeep too ! not hard to do your self at all.i paid 12.99 for one can at advanced auto

http://smileys.smileycentral.com/cat/15/15_6_1.gif Smoking tail lights is a gateway to other drugs. I think





http://www.smileycentral.com/sig.jsp...p=ZNxpt471YYCA

I'll do it for you, you just pay for the shipping costs and the cost of supplies.

go look at my pics, costed me about 20 bucks, vht nightshade and clear coat and plus some wetordry sandpaper

Here you go...
https://www.f150forum.com/f61/i-will...llights-35644/

mike you like the way i did my lights?

I did mine, very easy to do. Save yourself some money and feel proud....


[1] Remove taillights
[2] Wash with warm soap and water, degreaser soap of some type
[3] Taped off back up lights using automotive performance 3M green tape (has finest paint line) if you want reverse not to be tinted.
[4] Soft wet sand with 400 grit paper. You want to insure you sand all areas, nothing should be shinny, light should be hazzy when done. No need to sand hard.
[5] Wipe with clean rag so remove all dust.
[6] Applied 4 "light" coats of VHT NightShade (Pep-Boys carries this for around $12.00) waiting 20min between each coat. The more you do the darker it will be and you can always go back and do more coats if you want. Start with 3 coats.
[7] After finial coat I waited 2 1/2 hours then wet sanded with 1500 grit paper
[8] Wipe with clean rag and insure all is dry
[9] Applied 3-4 "heavy" coats of Krylon Fusion for plastic Clear UV. You can use others but this was my preference. After the first 2 coats I let it dry for about an hour and wet sanded again with 2000 grit.

All items were purchased at Pep-boys with a total of $37.98. Total time took about 6 hours.

After the lights curried over night, close to 24 hours, I grabbed the mini bullet polish bit and threw some plastic polish on them and gave them a double shine.



http://www.xperties.net/photos/d/33047-3/tails+001.JPG

Yea, yours came out clean

thanks bro but i was thinking about wet sanding it with 2000 grit and putter more clear coats on to shine it a little

Yes sir, I think it is...:thumbsup: