What did you do to your 11th gen today?
TOTM November 2019
iTrader: (2)
Painted a new tailgate emblem to match the badges, graphite with red vinyl overlay and clear. Turned out great!
Senior Member
Thread Starter
The following users liked this post:
Summers22 (03-05-2017)
Lost in Time
Join Date: May 2011
Location: North Dallas Forty, OC California
Posts: 521
Received 213 Likes
on
98 Posts
I have now read several places where on my truck since it is a 2wd, the front bearings in the Centric upgrade kit hub and the Power Stop have a very low life. I priced out Motorcraft front and rear rotors with Centric Posi-quiet ceramic pads (all what I am running now) and it comes to $438 shipped. Its under my $500 budget and no reason they wont last the life of the truck at this point. I would say 156K on originals is pretty good. Plus less worries of the front bearings going out early like the Centric and Power Stops I have read about on reviews.
The following users liked this post:
Summers22 (03-06-2017)
NIGHT TRAIN
Originally Posted by hahanson
Installed a level kit.
Before:
After:
Before:
After:
The following users liked this post:
hahanson (03-06-2017)
NIGHT TRAIN
Originally Posted by Summers22
Painted a new tailgate emblem to match the badges, graphite with red vinyl overlay and clear. Turned out great!
The following users liked this post:
Summers22 (03-06-2017)
Senior Member
Looks good Summers!
I pulled the trigger today on the Powerstop 1940 Z36 F&R brake kit with Z36 pads and new rotors. Went ahead and ordered two new "do not reuse" spindle nuts so my fronts don't fall off on the interstate.
Also pulled the trigger on a Belltech rear sway bar so I can keep up with the lowered ricers
I pulled the trigger today on the Powerstop 1940 Z36 F&R brake kit with Z36 pads and new rotors. Went ahead and ordered two new "do not reuse" spindle nuts so my fronts don't fall off on the interstate.
Also pulled the trigger on a Belltech rear sway bar so I can keep up with the lowered ricers
The following users liked this post:
Summers22 (03-06-2017)
Senior Member
how did you paint and then do vinyl overlay? Did you just spray everything then cut out the lettering and ring? I need to re do both my badges and this would be a lot easier than what I was planning to do.