Urgent brakes!!!
#1
Little Whitey
Thread Starter
Urgent brakes!!!
Just did my brakes about 2 weeks ago everything went fine until a caliper bolt on front right backed out. Replaced the bolt and now right front speed sensor is bad and I literally have no brakes. Fluid is topped off pads are new and I'm baffled. Any ideas???
#2
Mark
iTrader: (1)
Replace the speed sensor ...
#4
Mark
iTrader: (1)
Sends wheel speed signals to the abs system
#7
Little Whitey
Thread Starter
Bleed brakes after it was done yes. Thought air myself so decided to bleed brakes again and broke the front left bleeder valve. Don't ask me how but its broke. Now I need to try and extract the threaded part and get a new one. Now when replacing the wheel speed sensor can I do just the bad one or do I need to do both at the same time? Never had these types of problems before and it is starting to get very frustrating.
Trending Topics
#8
No as stated previously the wheel speed sensor is strictly for abs, it is butted up to a toner ring and sends an electrical signal to a computer, u will need to replace it but its not going to fix your no brakes issue. Being that the bleeder broke, I would think that it was seized in the caliper and the caliper is probably original. It is possible that the pistons in the caliper are seized, what does your pedal feel like? Does it go to the floor or what?