Fbcoach

Really? What makes it more than some? I thought the the -12mm offset would take some trimming out of the equation.

DirtRoadKid

Im assuming youve had bad experience in the past with 35's?

Allinkdupp

Not at all, I'm just stating the facts, I have a 3" lift and 35's and had minor trimming so a 2.25 level with 35's is going to have more than minor trimming with a -12 offset... That's just how it is

DirtRoadKid

So as long as he gets that extra half an inch he'll fit 35's? And wat kind of offset is needed then to fit? Cuz i got 33's on a -12 offset with a 3" level and im looking into getting 35's now

Allinkdupp

See, you should have "some" trimming if you get 35s cause of the 3" lift... He will have more than some with a 2.25 ( if he wants to turn)

DirtRoadKid

What kind of trimming did u do?

Allinkdupp

I trimmed a little off of the bumper valence and reshaped the rear plastic with a heat gun , think my backspace is 5, I can check for sure if you need me to because that comes into play as well

Fbcoach

Thanks for the advice, brother! I'll stick with 295s then. Would a 305/70 fit? That's under 35, right?

jbaker193

Ive got a 2.5" level kit and im running 35 cooper stt's. i had to trim the air dam a little and i still hace a little bit of rubbing on the wheel well. i also have rockstar xd 18" with a -12 offset.

SN95F150

I know, another wheel question...

I've searched and haven't found a definite answer. I own a 2004 2WD. I know, I know.. 2WD LOL. I came across this 4x4 while on vacation in Hawaii a while back. I know this one has a leveling kit, and I know the 4X4 is taller than a 4X2. My question is... What wheel specs should I go with to get close to achieve this look? I'm going to with a 33/12.5 for sure, but wanted a few suggestions here. Most likely will be a BFG AT or MT if I can get a good deal. Currently it's stock, with rancho quicklifts on order.


Any help would be greatly appreciated!!