Shelby GT500 Hood Vent Installed
#22
#23
12 Second Truck
Thread Starter
For what it's worth to those concerned...this is a Ford factory part used on the 2014 Shelby GT500. It's not going to cause problems. Now if you positioned it further back which would look bad, say another 12-18" back it would be over the alternator and engine which could eventually cause some issues.
Last edited by Blown Ford; 10-02-2013 at 10:10 AM.
#28
Senior Member
Just did this install after having the vent for more then 1 year.
Pretty straight forward after reading the step you used!
I would suggest: 12" behind the grill (or 10,5 at minimum) unless you are cuttin into the hood front reinforcement.
Mine came with double sided tape, so no silicone needed.
Here's the picture:
Hood reinforcement I was talking about:
Finished installation:
Pretty straight forward after reading the step you used!
I would suggest: 12" behind the grill (or 10,5 at minimum) unless you are cuttin into the hood front reinforcement.
Mine came with double sided tape, so no silicone needed.
Here's the picture:
Hood reinforcement I was talking about:
Finished installation:
The following users liked this post:
wkmounts (08-21-2023)