View Poll Results: does this thread help anyone else???
Voters: 3. You may not vote on this poll
Replaceing both 4WD IWE's and still GRINDING!!!!
#1
Senior Member
Thread Starter
Replaceing both 4WD IWE's and still GRINDING!!!!
I changed everything for the 4wd vacume system on my 05 xlt except the vacume lines but i tested them and they are fine. i just replaced both i.w.e.'s and cv joint shafts, and the new iwe's still grind at certain rpms and speeds. has this happened to anyone else? and does anyone have any input??? need a little help my wallet is suffering with this wild goose chace i got myself into....
#2
Senior Member
Did you perchance change the solenoid?
#4
Senior Member
Thread Starter
Yes I changed solenoid and I thought when wheel bearings go bad they will grind all the time....the sound I hear only happens at certain rpm and speeds.
#6
Have you checked the wheel speed sensors? Happened to me a few years back on an 06 f150 fx4. Dealership told me the wires got ripped out of the sensor (from offroading).
Trending Topics
#8
Mine did too... As far as it sounded from the dealer, it was a speed sensor for the anti-lock brakes, but it made my 4wd grind when I tried to shift on the fly....
Last edited by jc22; 08-15-2011 at 04:12 PM.
#9
Senior Member
The wheel speed sensors on the front end have nothing to do with your speedometer. They are part of the ABS.
#10
Senior Member
Thread Starter
thanks for the heads up and all the good info... i took off my cv shaft a little while ago and checked for any metal fileings and there was none even after the grinding noise came back... ill keep an eye on it but if anyone else has more input on this topic please post it on here thanks again.