ssgsmc19k

Has anybody used these? I have a leveling kit on my 07 4x4 Lariat Sc. That 4wheel parts says is a 2 in, but my front end is about 1/4 to 1/2 in higher than the rear. Oh I have checked the messerments on all 4 sides and all seem to be off by anywhere from 1/4 to 1/2 in. Is that normal? Thanks

SuperRhino

At what point on your truck are you measuring from? The Top of the wheel well?

This might sound stupid but do all of your tires have the same psi in them?

ssgsmc19k

I am meassuring from both the garage floor to bottom of center of wheelwell and from top of tire to bottom of wheel well. I dont know I think I might be crazy. Oh and the pressures are all same. Im gonna go with the readylift blocks I think. The truck tracks straight, and the tires are wearing the the same. Truck just went over 25K.

techrep

iTrader: (1)

sounds like you bought a 3 in. to me...no way a 2 in. would make the front end higher than the rear.

NashBulldawg

Agree with TECH..... the only way the 2 inch would sit higher in the front is if someone took out the 2 inch lift blocks that are from the factory on the rear.

SuperRhino

X3 agree

ssgsmc19k

yep damnit thats what I thought. My wife got it put on for me while I was gone. She told a 2in and when it was done the paperwork said 3in. The teck at 4wheelparts siad it was a 2in but had to order on paperwork as a 3in. Sound like they were covering there ***. Its the kind they take the strut apart. Paperwok does not say exacly what brand it is.