No "go" in higher rpm
#11
Junior Member
Thread Starter
Join Date: Feb 2017
Location: Colorado Springs, CO
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
Finally got IDS on my pickup and monitored several pids and performed self tests. Passed all test. The only pids I found that don't seem kosher is b2s1. This sensor is 2 months old and I'd say something about this reading is indicating an issue somewhere. Ether doesn't change the reading. I do realize b1s2 is indicating a bad cat, I've replace the cat since this picture was taken and this was before I replaced the 02 sensor that is reading the same, I didn't take one of today's data and remembered I had this one.
#12
Have you checked any data from the phasers and VCT's? Maybe the cam to crank timing is off? I've replaced timing belts in the past and been off 1 tooth which caused an extreme lack of top end performance. (Obviously the 5.4 is chain driven) I think you should double check your previous work.
Last edited by Nate782005; 08-02-2017 at 11:45 PM. Reason: thought of something else