How to setup LED pods/cubes?? (fog lights and reverse lights)
#1
How to setup LED pods/cubes?? (fog lights and reverse lights)
I have an 04 and I want to swap the factory fog lights for LED pods and also want to add some to the rear for reversing. Just curious if anyone had any suggestions or pictures of how they mounted theirs and also the best way to wire it. For the fog lights would be able to just tap into factory wires (I want to turn them on with the light ****) or would I need to add in a wiring harness? Same question with the reverse lights, and also the best way to wire that up.
#3
One set of flush mounted cubes in bumper and one set bolted to the rear shackle hanger. All wired to a relay harness and switch.
Attachment 390870
Attachment 390870
#4
Member
I have those cheap ones from Amazon and just took some angle iron and bolted it to the tow package. I also just tapped into the reverse signal of the trailer hookup there which was the center pin so the lights come on when I put the truck in reverse, nothing fancy. just practical.
#5
Member
I just ordered a 30" light bar and four 4" LED cubes for the fogs.
I will by H10 connectors, splice them to the LED cubes and just plug right in to the existing factory fog light connectors for the cubes so that they come on with the factory fog switch.
I will install a switch with a wiring harness and relay for the 30" LED bar.
Do you have the rectangle style fogs or the circle style fogs in your bumper?
I will by H10 connectors, splice them to the LED cubes and just plug right in to the existing factory fog light connectors for the cubes so that they come on with the factory fog switch.
I will install a switch with a wiring harness and relay for the 30" LED bar.
Do you have the rectangle style fogs or the circle style fogs in your bumper?
Last edited by markwerline; 08-10-2015 at 05:09 PM.