Fuel Pump Driver Module- Check yours!!
#201
Senior Member
All that nonsense with cleaning it, shaking it, drying it, and wrapping it in a ziploc takes a lot more time than one click to order a new one.
Your sweet fix with the ziploc bags will leak, and now you are just trapping moisture inside of your contraption, making it worse. I strongly advise against this.
Your sweet fix with the ziploc bags will leak, and now you are just trapping moisture inside of your contraption, making it worse. I strongly advise against this.
#203
That's a good idea. I wish I would have done that, I just installed my 3rd FPDM over the summer before the weather got bad. Cheap a** pot metal.......
#205
The first one was the original and blew out in the winter of 2012, Then the replacement was starting to crack this summer so I went ahead and replaced it with a new one. All came with spacers, I live in upstate New York so the salt/sand destroys everything up here.
#207
Senior Member
Just checked mine after issues getting to work..stumbling and only 1500ish rpm. After work started right up.. made it 4 blocks.and same issues..1500 rpm then lower and lower then die. Wait 10 min.. pri.e pump a few times.. can hear pump run but sounds a little coarse.. then start and make it 4 more blocks.. 5 miles later I'm home thinking fuel pump and see this post.. Pulled mine.. broke in half and dime size hole on the back. Am I on the right.track.. or is it fuel pump.. had 4 codes p0190..p0191..p0174 and another..fuel pressure sensor..lean.. ect..
#208
let us know .......but if the pump runs , I think the fuel module may not be a problem , course there are a lot of reasons why it may stumble , may or may not be fuel related , but first place I would look too is pump , I don't think pump would run if you had a bad module.
Dave
Dave
#210
TOTM November 2019
iTrader: (2)
Just checked mine after issues getting to work..stumbling and only 1500ish rpm. After work started right up.. made it 4 blocks.and same issues..1500 rpm then lower and lower then die. Wait 10 min.. pri.e pump a few times.. can hear pump run but sounds a little coarse.. then start and make it 4 more blocks.. 5 miles later I'm home thinking fuel pump and see this post.. Pulled mine.. broke in half and dime size hole on the back. Am I on the right.track.. or is it fuel pump.. had 4 codes p0190..p0191..p0174 and another..fuel pressure sensor..lean.. ect..