COP boots & springs
#11
Mark
iTrader: (1)
A small nail file...
The following users liked this post:
backshot (04-05-2018)
#12
Moderator
I use electrical contact cleaner and a small screwdriver to scrape the spade clean. The spring will really only contact the spade on the sides of the spade so make sure you get that cleaned up really well. Tech also has a good suggestion with the small nail file.
#13
Senior Member
Vinegar on a q-tip will remove the corrosion without scoring the connector.
#14
#15
#16
Junior Member
Thread Starter
The following users liked this post:
SilverSport (11-15-2019)
#17
Mark
iTrader: (1)
08's built after 10/09/07 require a different boot from most 04-08 5.4 3V motors.. key here is if you need black or brown boots.
#18
#19
Sh!tllbuffout