console question
#1
poopin.....on this thread
Thread Starter
console question
Has anyone put a full console with shifter hole from a lariat in their xlt without a floor shifter and turned the opening into an additional cupholder/cubby hole?
#2
ive been wondering the same thing. im pretty sure the dash is different towards the floorboard but i was thinking about using gauges in place of the shifter hole.i hope some one responds
Last edited by fol4321; 01-08-2013 at 11:50 PM.
#6
Senior Member
i have not seen it done, but you would either have to replace the center of the dash to make it flow or customer make your own panels to addapt to the non console shifter dash.
#7
poopin.....on this thread
Thread Starter
Ahh...I did not know that there was a difference in the location where the sad meets the floor shifter console. Guess ill just have to keep trying to find a normal xlt console. My jump seat is just so ugly.