VFL

Can this be done? I'm looking to eventually replace my strut assemblies and I figured, what a better time than to upgrade the coilovers at the same time. I'm currently using a 2.5" HBS spacer on top of my worn 2WD OEM coilovers. So, theoretically an adjustable 4WD 2" lift coil over should net around 3" of lift? Any good information would be appreciated

Z7What

Are the OEM 2WD and 4WD coil overs different?


Wayne

VFL

I have read that the 4WD coil overs have spring mounts that sit 1" higher than the 2wd versions.

Crusier02

I am currently running this all I did is change out the 2wd whole assem for a 4wd unit rides just a tad stiffer and sits about half to inch lower than a 2wd sits with a level on it I like it though and would never go back to my level I had before.

VFL

You had what size level on your 2wd coils? And went to which quick struts? Rancho?

Crusier02

I had a hellbent 2.5 on top of my 2wd so I put oem ford 4wd assembly in it that's what I'm running now.

VFL

So, would these 4WD coilovers be too much?

Z7What

Can 4WD coils and 2.5" leveling kit work on a 2WD?

Wayne

VFL

I doubt it. It would probably have way too much angle

VFL

http://www.gorancho.com/suspension.p..._4wd#quicklift

So these would net 2.5" plus the extra 1" being 4wd coils. All in all 3.5" would be the gain on these? Sounds like too much stress on the control arms