07 2wd front rotor bearings
#1
Senior Member
Thread Starter
07 2wd front rotor bearings
hey guys, went to midas after no longer being able to tolerate the shaking when i brake. they said my rotors were way out of spec and warped bad....but i knew that. quoted me $180 per rotor , $55 for pads and $100 labor. i laughed and walked out.
i have one question before i tackle this job myself. are the bearings in the rotor pressed in or can i pull them out by hand? if i can pull out by hand itll make buying new rotors and installing easy. i looked in a haynes manual but it didnt say.
i have one question before i tackle this job myself. are the bearings in the rotor pressed in or can i pull them out by hand? if i can pull out by hand itll make buying new rotors and installing easy. i looked in a haynes manual but it didnt say.
#2
Member
They have to be pressed in. You can take them to any brake shop and they can perform this for you. If you know any one with a press, you can do it yourself w/ a large socket, just go slow. DONT GREASE! We put the bearing in the freezer for a bit, and let the rotor sit in the sun, then pressed (heat expands, cold shrinks). There is a place online you can get the bearings for $80 for 2. http://www.jbr17llc.com/set930timken.html Good luck!