04 Scab rear seat install
#1
04 Scab rear seat install
So, I have an 04 Scab that I can't get the F-N rear seat to snap into place. I've got the passenger side fully clipped in, but I can't get the drivers side to go completely in. It'll go in, but it'll still have about half an inch to drop in. Anyone have ideas what I doing wrong or tips?
#2
Small update. Got the seat fully in, however, the backrest of the seat has about 1/2 inch of up and down movement. Is that normal? I haven't had the backrest in for about 6 months so I can't remember if it was like that before.
#3
Senior Member
Did you check to see if all the plastic clips are in place, I had mine out a few days ago and the passenger side went in good but the drivers side was sticking up and out about a 1/2 inch as well. Picked back up on the drivers side like I was taking it out and then pushed in real hard and pushed down, locked it in place like it was supposed to be then. Good luck
Tom
Tom
#5
Well I can reach between the cushions and feel that the bar is fully lowered into the retaining parts. But again, I can lift the seat up about 1/2 inch. It feels like it's secured and won't just pop out, it just has that play.....