Wrapped My Interior in Camo to Match My Seats
12-10-2015, 08:45 AM
#1
Active Duty Navy Chief
Thread Starter
Join Date: Oct 2014
Location: Washington DC/MD/VA Area
Posts: 1,066
Likes: 0
Received 210 Likes
on
170 Posts
Wrapped My Interior in Camo to Match My Seats
Just finished wrapping the door pieces last night in camo vinyl. I've had the dash done for a few weeks but finally got around to doing the door pieces.
One key part of this for all that may attempt.... Use an edge sealer! I wrapped my dash previously in a different pattern and didn't use edge sealer and some of the parts were coming unwrapped. Most flat surfaces are fine but parts where you have deep indentions may not hold if you don't use the edge sealer.
Here are some shots:
Last edited by discodave; 12-10-2015 at 08:56 AM.
The following users liked this post:
sigma pi (12-10-2015)
The following users liked this post:
safetypin (12-14-2015)
The following users liked this post:
safetypin (12-14-2015)
12-10-2015, 09:48 AM
#6
12-10-2015, 09:57 AM
#7
King Hater
How hard was that?
Trending Topics
12-10-2015, 10:19 AM
#8
Active Duty Navy Chief
Thread Starter
Join Date: Oct 2014
Location: Washington DC/MD/VA Area
Posts: 1,066
Likes: 0
Received 210 Likes
on
170 Posts
It's not bad at all. Vinyl wrapping is pretty easy if you have a heat gun. Like I said before, they key is using the edge sealer on the back of the pieces you wrap to make sure it never comes loose. It's basically glue that holds really well that's made for stuff like that.
12-10-2015, 10:46 AM
#9
King Hater
How did you do the door pieces? Are they easily removed?
