Were to run wires through Firewall?
#2
I ran my 4ga thru the passenger side just look for the rubber grommets. And pull down your glove box you'll have to use a coat hanger and tape the wire to it and pull it thru...I'll take a pic later when I get back to the shop.
The following 3 users liked this post by steelhauler:
#3
Senior Member
Also on driver's side by the steering column there is a gasket with other wires you can piggyback on. Did that for my KC lights so the switches would be on my side.
#4
Senior Member
Just behind and to the right of the gas pedal, there is a rubber plug in a hole ready to be used... the carpet is already cut out nicely too. (2010). Make certain you are careful not to leave any wire hanging loose in that spot though. lol!
The following users liked this post:
Gonnabehppy (11-01-2022)
The following users liked this post:
Mb Offroading (10-27-2012)
#6
The following 7 users liked this post by nate977p:
Edgesport (12-15-2020),
firecomm1 (09-20-2018),
Fstamigo (05-20-2023),
Husker991 (12-23-2013),
Mb Offroading (10-27-2012),
and 2 others liked this post.
#7
This is a great solution for the routing of an amateur radio (ham) transmission (coax) line. Worked great on my 2018. I only slit the small grommet on both sides, drove a small electrical screwdriver through. And then tried to "fish" the coax through with a hanger. (No-go the first 2 times.) I then used a cordless electric drill with a 1/8" spade bit and ran it through. It didn't create a hole (the rubber is too flexible, but it did create enough flexibility in the grommet that the third attempt to fish the coax was successful.
The following users liked this post:
kc3oqp (03-15-2023)
Trending Topics
The following users liked this post:
Scab10 (07-24-2019)