ranger_danger4x4

There isn't going to be any rubbing in the front wells?

goneMINIcrazy

Well I've got LTX A/T 2's at 275/60/20. That should come out to about 11" wide and 33" tall. I'm leveled 1.5" now, but at stock height I still had over an inch of clearance.

brantastic

My 275/70R18 Duratracs don't rub at all. No lift. No level. Although I'm getting a 1.5 front level for aesthetic reasons.

Signature didn't post. Truck is a 12 FX4 Screw.

Dakkon85

Think I've found a tire size 305/55 R20 terra grapplers or at2 extremes torn between these I'm wondering if these will fit and look good going with blisten 5100s up front and unsure what to do with the back as of yet will have to see wanting to use stock ford 20s for a bit while I save for rims I think the backspacing on them is max 6 1/4" 1.5"+ offset I think !!!!!!!!

DavidSchlot822

20x12 American Force Elite SS6s on 35X12.50R20 Federal MTs

HuskyKMA

Hey guys quick question.

Thinking about installing 295/60R20 with +20 offset wheels (33.9"x11.6"). Will I be able to fit these with Bilstein 5100s at the 1.5" setting or will I need to go with the top 2.25" setting? Would prefer no trimming be necessary but could probably deal with it if it's minor.

NCFX4

I have a 2012 FX4 screw 3:73 and here's the plan:
I've already ordered the Rancho Quick Lifts 2" leveling kit, includes the rear 9000xl shocks.
I'm reading posts and threads over and over for tire size help. Some say rub some say no problems at all...
I want to continue to use my 20" stock rims, but can't decide on tire size because I definitely do not want to rub or do any trimming or such. So I'm leaning towards the Toyo Open Country M/T's 295/60/20 on stock rims. My question is will this set up cause rub, the need to trim, or the need to use spacers? If these will cause any of these issues will someone please recommend the largest most aggressive brand and size that will not cause any issues..? As stated, I'm a newbie, so any help would greatly be appreciated. Thanks

CLABRO

Your tires are only a bit taller than the stock size and your offset isn't aggressive so I think you should be fine. If you need to bump it up to 2.25", I'll be surprised. It's also going to depend if you don't mind if it rubs at full lock or if you want it not to rub whatsoever.

CLABRO

Few cell phones pictures I found on my phone that I figured I'd post. Will be getting my DSLR out this weekend and taking some shots.

goneMINIcrazy

Did you ever pull the red PD off the spokes?