security system LED mounting location.
#1
Senior Member
Thread Starter
security system LED mounting location.
I have my 200 series all installed and working good. The only thing needed to do is drill a hole and mount the LED. Where are you guys installing it? Thanks
#3
Senior Member
The install instructions say to install it on the steering column. My truck has the power telescoping wheel so i think i am going to look at installing mine up on the dash by the dash/center speaker instead. I don't want to deal with a potentially binding cable or issues from it. Either that or on the panel where the 4x4 **** is.
I wont be doing that until the spring when temps here are above freezing though. too damn cold to pull apart the plastic parts.
I wont be doing that until the spring when temps here are above freezing though. too damn cold to pull apart the plastic parts.
#5
SS..DD
iTrader: (1)
The install instructions say to install it on the steering column. My truck has the power telescoping wheel so i think i am going to look at installing mine up on the dash by the dash/center speaker instead. I don't want to deal with a potentially binding cable or issues from it. Either that or on the panel where the 4x4 **** is.
I wont be doing that until the spring when temps here are above freezing though. too damn cold to pull apart the plastic parts.
I wont be doing that until the spring when temps here are above freezing though. too damn cold to pull apart the plastic parts.
#7
Senior Member
Thread Starter
The install instructions say to install it on the steering column. My truck has the power telescoping wheel so i think i am going to look at installing mine up on the dash by the dash/center speaker instead. I don't want to deal with a potentially binding cable or issues from it. Either that or on the panel where the 4x4 **** is.
I wont be doing that until the spring when temps here are above freezing though. too damn cold to pull apart the plastic parts.
I wont be doing that until the spring when temps here are above freezing though. too damn cold to pull apart the plastic parts.
Thanks for your response.
Trending Topics
#8
Senior Member
Thread Starter
#9
Was outside today looking at different places to mount the LED, was thinking of maybe putting it inside the little storage compartment on the passenger side dash, there is a clear view of it when looking inside the truck from the driver window. I'm not sure If I want it to be seen unless your actually looking in....
Last edited by Sonnn; 01-04-2014 at 02:34 PM.
#10
Member
I put my 200 series in a week ago and I put the led in the tray on top of the dash. Seemed like the easiest place to be drilling a hole for it. Just lift the mat out and there are 2 bolts that hold the tray in and with the glovebox dropped down it's a pc of cake to route it up there.
The following users liked this post:
Sonnn (01-04-2014)