Rear wheel inner fender liner
#11
Senior Member
I have them on my 2011 FX4 and have the WT mud flaps. They both share only one connection. Lining up a couple of the holes took some effort. I used a thin screwdriver to help line up the holes. Also, not sure why, but the passenger rear was more difficult to install than the driver side. Had to jack the rear end up, place a small 2x4 between the bottom of the liner and axle, and slowly lower the rear until the 2x4 pushed up the bottom of the liner and I could insert the liner clips that hold it in place. The drivers side slipped in without any problems.
This is a good tip too. I didn't remove my wheels and the pliability really helped.
Gook luck.
This is a good tip too. I didn't remove my wheels and the pliability really helped.
Gook luck.
#14
Junior Member
FYI. I put the Rugged liners in with the tires on. 15mins each side. Everything lined up and was a perfect fit. Really like the coverage behind the tires and how they cover the gap between the frame and the bottom of the bed. They where at my door in less than 24hrs.
WT mud flaps fit great with them.
WT mud flaps fit great with them.