Rear marker lights installed
#1
Senior Member
Thread Starter
Rear marker lights installed
I installed the raptor third brake not too long ago, I was contemplating adding the two outer lights however I didn't want it looking out of place, or cheap so I wasn't sure if i was gunna do it. I was a lil bored so i ordered some red leds from superbright, and installed them in a non-invasive way, so if i ever wanted to remove them, or i decide they dont look good, i can take em off w/o any damage, etc.
Over all i think they turned out pretty well, they dont stand or pop out, and i think blend in well. I think they go well with the fwd cab lights as well. Here are some pictures of the final outcome:
Night Shots: (not the best focusing)
These are the lights i used. I tinted them with rustoleum lens tint,did a lil wet sanding, then sprayed with clear.
Over all i think they turned out pretty well, they dont stand or pop out, and i think blend in well. I think they go well with the fwd cab lights as well. Here are some pictures of the final outcome:
Night Shots: (not the best focusing)
These are the lights i used. I tinted them with rustoleum lens tint,did a lil wet sanding, then sprayed with clear.
The following users liked this post:
eyeflyone2 (03-03-2013)
#2
Senior Member
Interesting.
#7
Senior Member
Thread Starter
Trending Topics
#8
how did you do the third brake lights
actually can you explain how you did this whole project i would like to know how you did it without drilling it looks really good.
actually can you explain how you did this whole project i would like to know how you did it without drilling it looks really good.
Last edited by Master12034; 01-28-2014 at 07:37 PM.
#10
Senior Member
Thread Starter