NEED HELP!! 5.0 lost throttle, low oil pressure light
#1
NEED HELP!! 5.0 lost throttle, low oil pressure light
Yesterday I was driving my 2013 F150 XLT with the 5.0L, The truck has about 75,000 miles, and I lost all throttle input. Then the wrench light came on the dash then the low oil pressure light. The oil pressure gauge was pegged at L. Immediately I shut the truck off. After checking the oil, the level was good, the truck cranked but would not start. After sitting a few minutes it started up and I got it of the road. But then it would not start again. About 30 minutes later it started for the tow truck driver. The dealer can't find anything wrong. I changed the oil less than 3 days ago, motorcraft oil and filter that both checked out ok. Has anyone experienced this?
Thanks
Thanks
#3
Member
2wd it's highly likely the throttle body is bad, 4wd could be either a xfer case issue or throttle body.
.
.
#4
I actually had this happen one time in my 40k miles I've put on my truck. It was right after I had the truck tuned so I was extra nervous. I waited a few minutes cranked her up and she has run like a top ever since. I hope you get some good responses here as I would like to know what causes this.
#5
The truck is 4wd but it happened in 2wd. The ford dealer said that the throttle body checked out. I just hope it dosen't happen again when I'm in the middle of nowhere going to and from school.
#6
Well it happened again!! This time I was on the highway passing a semi when the truck lost throttle response. The wrench light came on then the battery light. After 5-10 seconds it regained power. I plugged my code scanner in and the codes for a misfire in all 8 cylinders and U0109. That is a code for loosing connection with the fuel pump module. Never shut the truck off and drove it the 2.5 hours home. After I shut the truck off it would not start until it sat for 10 minuets or so.
#9
Mine did same thing
Mine did the same thing 2 days in a row, kicked check engine light this morning. Code reader showed open circuit on Fuel Pump Driver Module, just ordered new one. Let's see if that fixes the problem.