Lighted Sun Visors
#11
just be carefull when you remove your panels they have metal tension tabs use a panel trim removal tool and u should be ok
just buy the harness that plugs in place under headliner, you can by it from tasca parts, I bought one for $64.00 it has all connectors and prewired for the rear view mirror camera, headliner is not a problem taking out, but you can just let it lay on your seats and install harness, I will send you a shop service pic of how it comes out..
The following 2 users liked this post by edwards99:
SD_F1504x4 (11-18-2021),
sigma pi (02-15-2015)
#12
Senior Member
Sounds good!
#14
Senior Member
on the 2014 STX Sport these are prewired for lighted visors. The connector is tapped to the headliner. If you drop the driverside headliner you will see it tapped just over the driverseat. The passenger will be closer to the front of the windshield.
Also for those that are trying to run wires inside the arm for the visor toward the bottom will be fabric if you fold that over. you will see a lot of grease. clean that away and then there will be a plastic end piece. I use a flat head screw driver and needle nose to slide the rod away alittle away from it. you will be able to slide the wire from where the visor mounts toward the inside of the visor. You will have to use the needle nose to grab the wire near the plastic under the fabric and pull them through.
Also for those that are trying to run wires inside the arm for the visor toward the bottom will be fabric if you fold that over. you will see a lot of grease. clean that away and then there will be a plastic end piece. I use a flat head screw driver and needle nose to slide the rod away alittle away from it. you will be able to slide the wire from where the visor mounts toward the inside of the visor. You will have to use the needle nose to grab the wire near the plastic under the fabric and pull them through.
The following users liked this post:
steve392 (06-09-2015)
The following users liked this post:
SD_F1504x4 (11-18-2021)
#18
Senior Member
on the 2014 STX Sport these are prewired for lighted visors. The connector is tapped to the headliner. If you drop the driverside headliner you will see it tapped just over the driverseat. The passenger will be closer to the front of the windshield.
Also for those that are trying to run wires inside the arm for the visor toward the bottom will be fabric if you fold that over. you will see a lot of grease. clean that away and then there will be a plastic end piece. I use a flat head screw driver and needle nose to slide the rod away alittle away from it. you will be able to slide the wire from where the visor mounts toward the inside of the visor. You will have to use the needle nose to grab the wire near the plastic under the fabric and pull them through.
Also for those that are trying to run wires inside the arm for the visor toward the bottom will be fabric if you fold that over. you will see a lot of grease. clean that away and then there will be a plastic end piece. I use a flat head screw driver and needle nose to slide the rod away alittle away from it. you will be able to slide the wire from where the visor mounts toward the inside of the visor. You will have to use the needle nose to grab the wire near the plastic under the fabric and pull them through.
#19
King Hater