Lets see those Leveled out f150s!!!!
#3402
I got them at a local tire shop. They set me back $204.80 a piece. Not too bad! I just got them a couple of days ago. Love the way they feel but they do have a small amount of rougher ride with a little singing while driving. But not bad at all. Everything I have seen on them so far seem to be good reviews!
#3403
I got them at a local tire shop. They set me back $204.80 a piece. Not too bad! I just got them a couple of days ago. Love the way they feel but they do have a small amount of rougher ride with a little singing while driving. But not bad at all. Everything I have seen on them so far seem to be good reviews!
#3404
2" Daystar front, 2" autospring rear block
20x9 BMF Novakane 0 offset
275/65R20 Duratrac's
Minor trimming was needed in the front (both in front of and behind the wheel)
Ignore the white paint on the flare. They were PTM'ed but hot water and a hose took care of that
20x9 BMF Novakane 0 offset
275/65R20 Duratrac's
Minor trimming was needed in the front (both in front of and behind the wheel)
Ignore the white paint on the flare. They were PTM'ed but hot water and a hose took care of that
The following 3 users liked this post by RSMerc:
#3406
Senior Member
I'll be PTMing mine but they're being coated by a shop as you would any other panel then baked, just like factory...
#3407
Junior Member
This is the look I want man sick I have a 14 FX4 SCREW ECO and want to keep my original rims too what size tire are these ? How do they fit/run on your truck ? And do you have any pics of down the side of your truck I'd like to get an idea of stance thank you
#3409
I had a chip in one of them from the winter driving, and while washing it with hot water and a higher pressure hose, the paint came right off with a direct hit. So, I found a weak spot in each of them and was basically able to wash the paint off.
Im sure if you have them done by a body shop you wont have an issue.