Grandpa's Grocery Getter

I was told it will when I change my exhaust to duals might have to get a couple custom bends in there Im going out the back.......will know in a few weeks.......

Woo Sah

If you get a bolt on dual side exit, 45' (corner) exit, or If you get a custom job you will be fine. The normal rear exit bolt on, exit to close to the heat shield and the spare will be to close to the shield. I was going to take my bolt on to a custom shop to add a couple of bends to get the wide exit look I like (most auto styles). Right now I get a slight rattle from the exhaust vibrating on the heat shield depending on turning/RPM's.

Rutko

My XLT with a 2.5'' AS level kit.

I bought the 35's on 18x9 Rockstars with 0 offset for $600 but the setup is a little over the top for this old man plus the track is widened like 7'' which is great for cornering but I worry about long term negative effects. I'm going to throw them back on Craig's list and go back to my stock 18's (pictured below) and when tire replacement time comes I think I'll go up to 275/70's
[/IMG]

2.5'' AS level with stock 275/65-18's

colemac

Putting on 305/55/20s and just wondering if I should get a Pro Comp 2" level or the Rough Country 2.5" Its a 2012 Fx4 Supercrew and do you find the 2.5" better then the 2"?

BAD FOX

I've had the Rough Country 2.5" on both my 04 FX4 and 12 FX4, great product.

leveled5.0

ProComp 2 inch leveling kit, 275 70 18 Nito terra grapplers.

Grandpa's Grocery Getter

Im going to do a Maganaflow Kit, I have to change the rear with a custom bends , as Im putting on 36" BFG KM2's for my summer tires. I like the wide rear look, compared to when they are close together...to bad they didn't do it like the New Dodge's I think that looks sharp!

I hear ya On the wide auto look, I have Supercharged GTP Grand prix and love how it looks wide apart.

thanks for the post!

Grandpa's Grocery Getter

I put the Pro Comp 3" leveling kit and 2.5" rear aluminum block, I wanted the 1" block at the time but couldn't find one.....plus it works out better when hauling the quad, it stays level.......you probally seen this a 110 times but ehre it is again.....LOL but so far i love it and many compliements, always asking what lift I put in..lol.....but its just a leveling kit...lol.......can't wait to put my larger tires on in the spring......

Cheers

Dobie Hauler

2.5" Daystar leveling kit, XD Hoss 20x9 +18mm offset, Nitto Trail Grapps 305/55/20

jamesm03

im in the same boat. curious to see what you do.