Just leveled and put 35's on my '10 Screw PICTURES
#1
Just leveled and put 35's on my '10 Screw PICTURES
New to the forum but utilized all the info i found here for what i've done so far.
I put the AutoSpring 2.5 inch front kit and the Ready Lift 1 1/2 rear block kit. 295/65/20 Nitto Trail Grappler M/T's. They measure at 35.4 x just under 11 1/2 wide. There is about half an inch between the sidewall lug and the upper control arm. There is very very minor rub at full lock.
100 % stock:
Front lift only:
Front and rear lift:
Final Pictures:
I put the AutoSpring 2.5 inch front kit and the Ready Lift 1 1/2 rear block kit. 295/65/20 Nitto Trail Grappler M/T's. They measure at 35.4 x just under 11 1/2 wide. There is about half an inch between the sidewall lug and the upper control arm. There is very very minor rub at full lock.
100 % stock:
Front lift only:
Front and rear lift:
Final Pictures:
Trending Topics
#8
#9
Nice truck man, I just ordered me some 315/70/17s, gettin em on saturday with a 2" HBS leveling kit. Was also thinkin about getting the 1.5" rear blocks, was wondering how easy/hard they were to install yourself?
#10
the rear was very easy! probably only took me 20-25 min total... leave the axle on the ground, unbolt it, raise the truck from the leaf springs enough to change out the blocks. lower and put new ubolts on. easy as that. the front was a different story... the front probably would have taken me a lil over an hour but I didnt have a 30mm socket. and then when i bought one, they only had a regular socket and i needed a deep socket. so i ended up having to grind down the end of the bolt. so it took longer than expected. I had a second set of hands for the front which also helped alot