Getting Flowmasters...straight out the back or out the rear sides???
#11
Senior Member
Join Date: May 2010
Location: Michigan
Posts: 664
Likes: 0
Received 0 Likes
on
0 Posts
My vote would be for out the back.
Something to keep in mind if you are leaning towards in front of the rear wheel exit is over time it can discolour the wheel center and lead to premature corrosion of your wheels. Remember the “97” model year that had that set up? I worked at a dealership and there was a TSB issued for correcting the wheel centers discolouring and customers were getting new exhausts from the converter back that exited aft of the rear wheel. Good deal for them. I bet it was considered a mistake by Ford. I looked cool though.
Jim
Something to keep in mind if you are leaning towards in front of the rear wheel exit is over time it can discolour the wheel center and lead to premature corrosion of your wheels. Remember the “97” model year that had that set up? I worked at a dealership and there was a TSB issued for correcting the wheel centers discolouring and customers were getting new exhausts from the converter back that exited aft of the rear wheel. Good deal for them. I bet it was considered a mistake by Ford. I looked cool though.
Jim
he said behind the rear wheels not the front
#12
Senior Member
Thread Starter
Join Date: Jun 2010
Location: Raleigh, NC
Posts: 274
Likes: 0
Received 0 Likes
on
0 Posts
#13
I had the shop put them right behind the rear wheels on both sides like the single stock exhaust is angled. I dont like how they look straight out, personally, and i've seen a lot of trucks with straight out that have one sagging lower than the other after a while... that would make me a little angry.. haha