Greg Owen |
09-29-2015 03:03 PM |
Found a Future Rust Pocket...
4 Attachment(s)
Maybe this has already been covered, but if not, y'all might want to check this out on your own trucks.
So, I was in the planning stages today of doing a mod where I need to get behind the front fenders. The easiest access is loosening the wheel well liners.
Well, you wouldn't believe the crap I found at the aft end, near the front door hinges! I was working on the driver's side first and cleaned it all out before deciding to take pictures. The pictures from the pax side are a before and after, and you can see how much crap was packed in there. And that doesn't include what I blew out with the air hose afterwards.
When I was working on the driver's side, I was out in my driveway, that is until it started to rain. I can tell you this though, water does get down in this area, too, because in the time it took me to put the nose of the truck in the garage to work on the pax side, water was already dripping from this area. In one of the pics, you can actually see a "water trail" down to where this pocket of crap was packed.
If you're going to check yours out, there are 4 screws (7/32") holding the liner in place, but you only need to remove 3 of them to clean this area out--the 2 at the bottom aft, and another located at about the 10 o'clock position on the pax side; 2 o'clock position on the driver's side. Then you can peel the liner back enough to clean this area out.
|