Interior foot well lights.
#1
Senior Member
Thread Starter
Interior foot well lights.
I want to wire up some LED lights down by my feet on driver and passenger sides. The LED strip lights I have are adhesive.
Where and how have you guys installed them?
Any pictures?
I want them to turn on with the interior light switch and when the doors are open.
Where's the best place to tie in the power?
Thanks.
Where and how have you guys installed them?
Any pictures?
I want them to turn on with the interior light switch and when the doors are open.
Where's the best place to tie in the power?
Thanks.
#2
Senior Member
I have the driver side light power wire running over to the passenger side and then tied into the big green connector.
The adhesion worked for me on one side, the other side needed help so I used the clamping style paper clips.
ill get pics on lunch.
The adhesion worked for me on one side, the other side needed help so I used the clamping style paper clips.
ill get pics on lunch.
#3
did the same but i added 3m two sided tape to mine so no problems with them sticking
i also tapped the green plug in the passagners foot well with some posi-taps and the ground to the fuse box screw
post #10 and 14 from JP helped
https://www.f150forum.com/f38/footwe...needed-270954/
#4
Senior Member
Ahhh great! there we go, I can now just nap on lunch and dont have to take pics
Thanks!
Thanks!
#5
The leds I used are about 4" long with 6 leds per strip. These provide me enough light without blinding me where I open a door. What you might want to do is wait until dark to figure out a good place to mount. My truck has the console.
Drivers side
Passenger side
Drivers side
Passenger side
The following users liked this post:
buzzard bait (02-01-2015)
#7
Member
Autozone 12" strips. Comes in a pack of 2. Wired into the Gray/Purple wire underneath the driver side step panel so it turns on when the interior lights come on. They come with 3m adhesive on the back so I just stuck them to the metal dash supports.
Trending Topics
#8
Senior Member
Thread Starter
Thanks guys. Got them wired in. Made a bracket on the passenger side out of tin to stick the led strip to. Worst part was getting the led to stick to plastic on the drivers side. Ended up sticking it to the metal bracket of the OBD connector. Kept falling off when stuck to the plastic.
#9
Senior Member
#10
Senior Member