DeeZee Tailgate Assist (aka EZ-Down) different versions
#12
Senior Member
Even the new design has its problems. The nutsert that goes into tailgate keeps loosening and pulling out. It will tighten back up but after a few drops it will start to pull out. I'm thinking about just drilling and tapping and install the ball bolt.
#13
Senior Member
I know this is to allow the tailgate to slowly lower, but does it also keep the tailgate from bouncing when it is open? I have the bed extender and that does the job holding the tailgate down, but it would be nice to only mount the tailgate extender to contain certain loads.
Thanks,
WGW
Thanks,
WGW
#14
Retired and loving it!
Who are you folks talking to at DeeZee to get your replacement strut? The person I talked with in customer service would not even begin to talk with me unless I could send him the proof of purchase.......for something that I bought two years ago???? I had so much trouble with the strut and the cord that I left on on for only a couple of weeks, then took it off and threw it out......are you folks able to get the replacement strut without the receipt.....
#16
Retired and loving it!
I would be interested to see if the new design alleviates that problem....
#17
Senior Member
iTrader: (1)
I put the new design on my 2013 a couple weeks ago. No problems yet except for the tailgate comes down much faster than the original design I had on my 2011. Is there a way to increase the resistance in the cylinder? I am thinking about installing a second one on the passenger to try to slow the tailgate down.
#19
Senior Member
As another poster says the cost isn't extreme if it sux bad I'll yank it. I went to me local truck/car shop and picked one up. Manufacturing date on the package as seen on the picture is 04/13 and it seems to have a blue bottle in it, possible Lock Tight? After opening it the instructions show up to model year 2004-2012 so they didn't update the instructions for the blue lock tight but thanks to the post I'll put it on every thread to ensure they don't back out.
I'll report on the shock/piston "stiffness" after the install but by hand it was a real SOB to extract the rod so we'll see.
I'll report on the shock/piston "stiffness" after the install but by hand it was a real SOB to extract the rod so we'll see.
#20
Member
I ordered mine from Amazon about 2-3 months ago and received the same one as in the version 3 pic form the OP.
Been very happy with it thus far, although I only open the tailgate on weekends to get my golf clubs out of the back.
Been very happy with it thus far, although I only open the tailgate on weekends to get my golf clubs out of the back.